3.33 EDH0162En1040 – 06/99
MM4005 CX — Define X position to reach with an
arc of circle = ƒ (CX, CY)
Usage IMM PGM MIP
Syntax CXnn
Parameters
Description nn
[double] — X coordinate to reach with an arc of circle.
Range nn — -1.0 E
12
to 1.0 E
12
.
Units nn
— Defined motion units.
Defaults nn Missing: Error C.
Out of range: Error C.
Description This command defines to the controller X position to rich with an element
of trajectory of the type: arc of circle = ƒ (CX, CY).
Returns None.
Errors C — Parameter out of limits.
V — Too long trajectory.
e — Trajectory: Units not translationnal or not identical.
Rel. Commands CY — Define Y position to reach and build an arc of circle = ƒ (CX, CY).
XE — Tell the last element.
EL — Erase the last element of trajectory.
Example NT | Clear trajectory.
CX10 | Define X position of an arc of circle = ƒ (x, y).
CY10 | Define Y position an build an arc of circle = ƒ (x, y).
XE | Tell last element.
XE, Arc (x, y), 10, 10, 90 | Controller tells the built element.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
