Newtec EL170 - Auto Switching 10;100;1000 Base-T Ethernet Interface; Layer 2 Bridge Mode: Ethernet Frames over Satellite; Layer 3 Bridge or Router Mode: IP Packets over Satellite; Proxy ARP Support

Appendix C – Technical
Specifications
User Manual for EL170/970/470 IP Satellite Modulator/
Demodulator/Modem
version 4.2
190
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
Monitor and control interfaces
• Web based GUI;
• Diagnostics report, alarm log;
• RMCP over TCP-IP/UDP and RS232/RS485;
• SNMP v2c.
Alarm interface
• Electrical dual contact closure alarm contacts;
• Connector 9-pin sub-D (F);
• Logical interface and general device alarm.
Physical
• 1RU, width: 19”, depth 51 cm, 6 kg;
• Power supply: 90-130 & 180-260 Vac, 105 VA,47-63 Hz;
• Temperature:
- Operational: 0°C to 40°C;
- Storage: -40 to +70°C;
• Humidity: 5% to 85% non-condensing;
• CE label.
EL470 IP Satellite Modem
Input Interface
• Auto switching 10/100/1000 Base-T Ethernet interface;
• Maximum rate: 133 Mbit/s in each direction, or 200Mbit/s Tx+Rx or 67,000
packets per second Tx + Rx;
• Layer 2 bridge mode: Ethernet frames over satellite;
• Layer 3 bridge or router mode: IP packets over satellite;
• Proxy ARP support;
• Base Band Frame input (optional);
• Supported encapsulation modes:
- Data piping;
- Ultra Lightweight Encapsulation (ULE);
- Multi Protocol Encapsulation (MPE) Extended Performance
Encapsulation (XPE) - Newtec’s highly efficient encapsulation protocol
for the encapsulation of Ethernet/IP frames in DVB-S2 Base-Band
frames.
• Filtering and routing capabilities:
- Up to 32 VLAN filters;
- Up to 255 MAC filters;
- Up to 255 IP routes/air-MAC addresses;
- Up to 256 PIDs;
- Up to 16 DVB-S2 Streams.