Newtec EL170 - Changing Parameters

Graphical User Interface (GUI)
User Manual for EL170/970/470 IP Satellite Modulator/
Demodulator/Modem
version 4.2
86
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
6.4.3 Changing Parameters
When logged in as administrator or as normal user, it is allowed to change
parameters.
Use one of the following methods to change the parameters.
• Using the editable parameters in the functional blocks (used to edit the common
used functions);
• Using the tree structure parameter pages.
The Wizards function is the easiest way to create a new configuration on your
demodulator.
The Wizards function is only applicable for users with an expert
profile. It is highly recommended to perform a configuration reset (refer to section
6.5) to clear the existing configuration before using the Wizards.
Experienced users can adjust individual parameters without the aid of the Wizards.
Proceed as follows to adjust parameters:
 Click the Overview tab or the Tree tab;
 Two possibilities:
• The Overview tab, click the detailed view icon (
) of the functional block that
contains the parameter(s) to be adjusted;
• The Tree tab, navigate to the parameter page that contains the parameter(s) to
be adjusted;
 Click the Editable icon (
) next to the parameter;
 Insert or choose the new parameter value;
 Save the parameter value;
 Edit more parameters in the same way if needed;
 Save the new configuration.