Full Color Card Printer PR-C101/C101M
38
After clearing the errors above, pressing the CLEAR Key clears the errors and [Ready to
Print] is displayed.
If the following messages appear, resolve the problem according to the instructions below.
Are there any scratches or dirt on the card's magnetic strip?
⇒Use undamaged cards.
Is the magnetic characteristics of the card matches the version of
the magnetic encoder and the setting of the magnetic encoder?
⇒Check the version of the magnetic encoder.
→See "Checking the Program Information and Serial Number" on page 29 for
instructions on how to check the version of the magnetic encoder.
⇒Change the settings of the magnetic encoder.
→See "Changing the Magnetic Encoder's Settings (PR-C101M Only)" on
page 30 for information about changing the settings of the magnetic encoder.
Reading of the magnetic data failed.
⇒Press the CLEAR Key.
Failure when reading the magnetic data may mean the following:
Is the card set in the correct direction?
⇒Check the loading direction of the cards.
→See "Loading Cards" on page 9 for instructions on loading cards.
Are there any scratches or dirt on the card's magnetic strip?
⇒If there are any dirt on the card, remove them.
⇒You cannot use the card with the scratches on the magnetic strip.
An error occurred that requires repairs.
The cause of the error differs depending on the error code.
⇒Turn off and on the power or hold down the CLEAR Key for 3 seconds
to reset the printer.
Repairs are necessary if the error reoccurs.
Message Solution
Press the CLEAR Key.
Correctly close the cover.
Error message Cause and solution
MG Read XX-XX
Service C. XX-XX
Push CLEAR key.
Cover Open
PR-C101_C101M_E.book Page 38 Monday, August 27, 2007 11:16 AM
To Next Page
Loading...
Need help?
General
