EasyManua.ls Logo

NMC-WOLLARD 140 - Installation; Radiator; Rear Suspension; Removal

NMC-WOLLARD 140
585 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 3-8
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
3.3 REAR SUSPENSION
3.3.1 Removal
󰀨
2. Place axle jack under axle. Raise slightly.
3. Remove nut and washers from axle plate.
4. Lower axle.
5. Remove front spring bolts.
6. Remove top shackle bolts.
7. Tip front of spring forward, down, and out.
3.3.2 Installation
Install in reverse of removal sequence. Refer to Section 1 and 3.1.11 for

3.4 RADIATOR
If a tractor radiator leaks, do not attempt to repair it by pouring any substance into

and water pump.


3.4.1 Removal
1. When engine is cool, remove transmission oil cooler from radiator.
2. Drain cooling system.
3. Disconnect upper and lower hoses. Replace if bulged, cracked, or leaky.
4. Remove radiator mounting fasteners and remove radiator.
3.4.2 Installation
1. Install radiator and secure with fasteners.
2. Connect hoses. Use new clamps if old clamps are corroded or faulty.
3. Fill cooling system.
4. Install transmission oil cooler assembly.
5. Start engine and check for leaks and proper operating temperature.

Table of Contents

Related product manuals