NMC-WOLLARD 140 - Figure 1-24: Setting Popup Status; Setting Popups

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 5-117
CHAPTER 5 MANUFACTURER’S INFORMATION
25
NexSysLink
®
2" Stand-Alone CAN Display Operation Manual  SAE J1939
© 2011 Beede Electrical Instrument Co., Inc.
• Setting Popups
Enabling popups allows the Fault, Warning and Alarm screens to appear when a when a System Fault,
Warning or Alarm condition occurs�
Figure 1-24: Setting Popup Status
Exit
Display
Popup-Disabled
Display
Popup-Enabled
Popup
Units-English
Scroll down to the Exit option and press the Enter switch or
wait 30 seconds for the last displayed CAN parameter to appear.
Pressing the Enter switch toggles the popup setting to
disabled. Press the Enter switch to toggle the units back
to enabled.
When the selection arrow cursor is placed next to the
Popup option, the name changes to Popup and the current
setting, i.e., Popup-Enabled or Popup-Disabled.
Pressing the Enter switch toggles between the two settings.
The setting is automatically saved once changed.
From the Setup menu, scroll to place the selection arrow
cursor next to the Popup option, Main Menu-Setup-Popup.
CAN DISPLAY MANUAL
OCTOBER 01, 2015