NMC-WOLLARD 140 - Added

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 4-15
CHAPTER 4 REPAIR PARTS
JANUARY 31, 2008
4 ILLUSTRATED PARTS LIST
Fig.-
Item
NMC
Wollard
Part No.
Vendor
Part No.
Nomenclature E󰀨 Units
Per
Assy
6- Brake, Disc Brake, Caliper Ref
1 41822 06-61460R Caliper, Disc Brake LH (NOTE: Casting is
stamped R)
1
41823 06-61460L Caliper, Disc Brake RH (NOTE: Casting is
stamped L)
2 41829 06-61655 Screw, Caliper Mounting
Blue Loctite
4
3 41830-1 06-62085 Pad, Disc Brake, Set of 4 Machined 1
4 42913 22660 Screw, Bleeder, GM Caliper (NAPA) 2
5 42176 06-61654 Caliper Bushing 4
IMPORTANT: Small metal tabs project through the mounting holes of the outboard
brake pads on the outside of the caliper. To keep the pads from oating, peen the tabs
over the edge of the hole. This should extend the life of the outer pad and eliminate
premature rotor wear. Do this in assembly with the rotor while applying pressure to the
caliper to prevent the mounting bolts from bending. To insure that the caliper oats check
for adequate grease in the caliper mounting sleeves, we recommend Stalube #3303
synthetic brake caliper grease with added graphite and teon.
NOTE: Always install calipers with bleed screw to top.