NMC-WOLLARD 140 - Editing Alarms; Figure 1-17: Editing an Alarm

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 5-110
CHAPTER 5 MANUFACTURER’S INFORMATION
18
NexSysLink
®
2" Stand-Alone CAN Display Operation Manual  SAE J1939
© 2011 Beede Electrical Instrument Co., Inc.
• Editing Alarms
The Edit Alarms function is used to change an alarms existing CAN parameter, higher/lower than
threshold indicator or trigger value�
Figure 1-17: Editing an Alarm
Change? 10.0 V
A1 Alternator Volts
Save Alarm
Save Alarm
No Change
0.0 V
A1 Alternator Volts
Delete Alarm
Edit Alarm
Change? 10.0 V
A1 Alternator Volts
Return
Edit Alarms
After choosing to either save or discard alarm changes, the same
alarm conguration screen appears to allow users to re-edit the
alarm if necessary.
Once the displayed alarm conguration is acceptable, press the
Down switch to scroll to the next alarm if one is congured or to the
Add Alarm and Return menu options.
With the selection arrow cursor next to the Save Alarm option,
press the Enter switch to save alarm changes.
Pressing the Enter switch after accepting the existing or edited
trigger value opens the save options menu choices.
To discard changes to the alarm, press the Enter switch to select
No Change. Otherwise, scroll down to place the selection arrow
cursor next to the Save Alarm option.
The alarms conguration screen appears with the blinking bar
cursor beneath the CAN parameter name.
Step through and edit the parameter name, threshold direction
and trigger value as desired using the Up and Down switches.
Pressing the Enter switch accepts and sets any changes.
After choosing an alarm to change, the selection arrow cursor
appears next to the Edit Alarm, option.
Press the Enter switch to begin editing the chosen alarm.
Pressing the Enter switch displays the rst previously congured
CAN parameter for alarm notication, A1.
The prompt “Change?” appears in the lower left corner of the display.
Press the Enter switch to accept the prompt to change/edit the
the displayed alarm, A1.
If more than one alarm exists, scroll down to display the desired
alarm then press the Enter switch to change/edit it.
From the Alarms Menu place the selection arrow cursor
next to the Edit Alarms option, Main Menu-Alarms-Edit Alarms,
then press the Enter switch to begin editing alarms.
CAN DISPLAY MANUAL
OCTOBER 01, 2015