EasyManua.ls Logo

NMC-WOLLARD 140 - Inspect Linings, Pads, Calipers, Wheel Cylinders, Etc

NMC-WOLLARD 140
585 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 1-17
CHAPTER 2 MAINTENANCE
1 SERVICING
AUGUST 31, 2008
1.5.4 Inspect Linings, Pads, Calipers, Wheel Cylinders, etc.
To minimize risk of brake system failure and possible accident,
when servicing brakes or brake system:


Compressed air used to service brake components must be oil-free or
rubber parts may be damaged.
Always replace brake lines that are questionable.
Never allow brake system rubber parts to come in contact with gasoline,
diesel fuel, or any type of cleaner other than an approved brake cleaner.
Wash hands before handling brake components.
Brake linings that contact oil or grease can become contaminated, lose
braking friction and then must be discarded.
Any brake service, other than periodic inspection or bleeding,
should be performed only by personnel specially trained in brake service.
Improper and poor quality service procedures can result in brake system
failure, loss of vehicle control, and personal injury.
IMPORTANT! Clean brake system rubber parts in clean, denatured



󰀩
Your inspection should be thorough.
Using non-original replacement parts is not recommended.
󰀨

Table of Contents

Related product manuals