EasyManua.ls Logo

NMC-WOLLARD 140 - Belt Tension and Condition; Every 500 Operating Hours or 6 Months; Installing or Adjusting Belts; Rear Axle Oil Level Check

NMC-WOLLARD 140
585 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 1-15
CHAPTER 2 MAINTENANCE
1 SERVICING
1.4.14 Replace Air Cleaner Element.
󰀩
1. Remove retaining strap securing dust cup to canister and remove dust
cup.
2. 
to canister and remove element. Do not remove or clean the secondary

3. Direct compressed air, DO NOT EXCEED 30 PSI, from the inside to the
outside of the primary element by inserting air nozzle inside element. Blow
loose particles by holding nozzle at least 6” from element.
4. Clean inside of canister with a damp, lint-free cloth. Also clean dust cap
󰀪
5. Remove air cleaner inlet cap. Wash cap with water and wipe dry with a
clean cloth.
6. 󰀪
cap. Secure dust cap to canister by tightening retaining strap.
7. Install air cleaner inlet cap.
8. Check and tighten all air induction connections before resuming
operations.
9. 
1.5 EVERY 500 OPERATING HOURS OR 6 MONTHS
1.5.1 Belt Tension And Condition
1. 

2. 
pivoting alternator or power steering pump. Replace belt if worn, cracked,
or frayed.
1.5.2 Installing or Adjusting Belts
1. Adjust or install a belt by pivoting the alternator or power steering pump on
its mounting brackets:
2. Loosen fasteners holding pump or alternator to their mounting brackets.
3. Change position of alternator or pump to give correct tension. Tighten
fasteners.
4. Recheck belt tension.
5. If you installed a new belt, recheck belt tension after 25 hours of operation.
1.5.3 Rear Axle Oil Level Check
1. 
wheel end and one on the axle housing.
AUGUST 31, 2008

Table of Contents

Related product manuals