NMC-WOLLARD 140 - Page 142

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 3-14
CHAPTER 2 MAINTENANCE
16. Position transmission rear support and insulator assembly above cross member
and lower transmission into place. Install mounting bolts and tighten to torque

17. Remove jack.
18. Connect vacuum line to vacuum diaphragm making sure that line is in retaining
clip.
19. Connect oil cooler lines to transmission.
20. Connect downshift and manual linkage rods or cable controls to their respective
levers on the transmission. Refer to parts illustrations in Chapter 4.
21. Secure starter motor in place with attaching bolts. Connect cable to terminal on
starter.
22. 
case.
23. 
24. Install converter housing access cover and secure it with attaching bolts.
25. Slide forward and connect it to transmission park brake drum. Connect park
brake cable to park brake lever.
26. Adjust shift cable as required. Refer to 2-1 - 1.9.3.
27. 
procedures in 2-1 - 1.9.3. Check for leaks.
28. Connect neutral switch wire to plug connector.
29. Connect temperature sender wire.
30. Connect the battery negative cable.
31. Lower tractor. Start engine and again check for leaks.
AUGUST 31, 2008
3 REMOVAL AND INSTALLATION