Configure a Beacon G6
Network configuration
Configuring Upstream (US) Classifier
Table 7-20 US Classifier - Classifier parameters (continued)
Select the toggle button to enter a protocol.
Select the toggle button to enter a destination MAC address.
Select the toggle button to enter a destination IP address.
Select the toggle button to enter a destination port.
Select a priority level from 1 to 8. The lower the number, the higher the priority. Only one classifier can
be created with the same priority.
6
Click Save. The US classifier is listed in the classifiers table.
To delete a classifier, click Delete next to the classifier entry in the table. A classifier can only be
deleted if it is not associated with any classifier rules.
7
Select the Classifier Rules tab.
All classifier rules are displayed in the classifier rules table in the page.
Use subject to agreed restrictions on disclosure and use.
112 3FE-49949-AAAA-TCZZA
To Next Page
Loading...
