Configure a Beacon G6
Security configuration
Configuring the URL filter
Table 7-33 IP filter parameters (continued)
Enter the remote subnet mask.
Select an application protocol or select ALL from the list.
3
Click Save.
END OF STEPS
7.47 Configuring the URL filter
Note: You can add up to 100 URL filters.
1
Click Security→ URL filter in the left pane. The URL filter page displays.
Figure 7-47 URL filter page
Note: You cannot use URL filtering for HTTPS. The URL is encrypted when using HTTPS.
2
Configure the following parameters:
Table 7-34 URL filter parameters
Select the toggle button to enable the URL filter.
Use subject to agreed restrictions on disclosure and use.
140 3FE-49949-AAAA-TCZZA
To Next Page
Loading...
