Nokia Beacon G6 - Configuring the MAC Filter; Table 7-30 Firewall Parameters

Configure a Beacon G6
Security configuration
Configuring the MAC filter
Beacon G6
2
Configure the following parameters.
Table 7-30 Firewall parameters
Field
Description
Security level
Select the security level from the list:
• High: Pre-routing and application services are not supported. UDP Port 8000 can be used
to access the services. For example, FTP can use 8021 and Telnet can use 8023. Regular
UDP cannot be used. RG access is permitted via the LAN side but not via the WAN side.
• Low: All outbound traffic and pinhole-defined inbound traffic is allowed. Pre-routing is
supported: port forwarding, DMZ, host application, and host drop. Also supported are
application services: DDNS, DHCP, DNS, H248, IGMP, NTP client, SSH, Telnet, TFTP,
TR-069, and VoIP. The following types of ICMP messages are permitted: echo request and
reply, destination unreachable, and TTL exceeded. Other types of ICMP messages are
blocked. DNS proxy is supported from LAN to WAN but not from WAN to LAN.
• Off: All inbound and outbound traffic is allowed. No firewall security is in effect.
Attack Protection
Select Enable or Disable from the list to enable or disable protection against DoS or DDoS
attacks.
Default value: Enable.
3
Click Save.
END OF STEPS
7.45 Configuring the MAC filter
1
Click Security→ MAC filter in the left pane. The MAC filter page displays.
Use subject to agreed restrictions on disclosure and use.
136 3FE-49949-AAAA-TCZZA
June 2022
Issue 1