ANSI CPE safety guidelines
Electrical safety guidelines
2. This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION
Service Disruption
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Resistibility requirements compliance
The customer premises equipment complies with the requirements of ITU Recommendation K.21
for resistibility of telecommunication equipment installed in customer premises to overvoltage and
overcurrents.
Electrical safety guidelines
This section provides the electrical safety guidelines for the customer premises equipment.
Beacon G6 devices are compliant with the following standards
• IEC-62368-1
• UL-62368-1
Note: The devices comply with the U.S. National Electrical Code. However, local electrical
authorities have jurisdiction when there are differences between the local and U.S. standards.
Power supplies
The use of any non-Nokia approved power supplies or power adapters is not supported or
endorsed by Nokia. Such use will void any warranty or support contract with Nokia. Such use
greatly increases the danger of damage to equipment or property.
Cabling
The following are the guidelines regarding cables used for the customer premises equipment:
• Use only cables approved by the relevant national electrical code.
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA 35
To Next Page
Loading...
