Configure a Beacon G6
Maintenance
Overview
Maintenance
7.28 Overview
7.28.1 Purpose
This section describes the maintenance tasks supported by the Beacon G6 WebGUI.
7.28.2 Contents
7.28 Overview
7.29 Configuring the password
7.30 Backing up the configuration
7.31 Restoring the configuration
7.32 Upgrading firmware
7.33 Diagnosing WAN connections
7.34 Viewing log files
7.29 Configuring the password
A password must adhere to the following password rules:
• The password may consist of uppercase letters, lowercase letters, digital numbers, and the
following special characters ! # + , - / @ _ : = ]
• The password length must be from 8 to 24 characters
• The first character must be a digital number or a letter
• The password must contain at least two types of characters: numbers, letters, or special
characters
• The same character must not appear more than 8 times in a row
When the password meets the password rules, the application displays the message “Your
password has been changed successfully”.
When the password does not meet the password rules, the application displays a message to
indicate which password rule has not been followed, for example:
• The password is too short
• The password is too long
• The first character cannot be a special character
• There are not enough character classes
1
Click Maintenance→ Password in the left pane. The Password page displays.
June 2022
Use subject to agreed restrictions on disclosure and use.
Issue 1 3FE-49949-AAAA-TCZZA 115
To Next Page
Loading...
