ETSI CPE safety guidelines
Safety standards compliance
Figure 2-1 Sample safety labels
The customer premises equipment complies with the requirements of EN 60950-1, Safety of
Information Technology Equipment for use in a restricted location.
• ETS 300 019-2-1 Storage Class T1.2
• ETS 300 019-2-2 Transport Class T2.3
• ETS 300 019-2-3 Stationary Class T3.2
2.3.3 Environmental standard compliance
The customer premises equipment complies with the EN 300 019 European environmental
standards.
2.3.4 CE RED RF Radiation Exposure Statement
This device complies with CE RED radiation exposure limits set forth for an uncontrolled
environment. To comply with CE RED RF exposure compliance requirements, this grant is
applicable only for mobile configurations. The antennas used for the transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
2.3.5 Resistibility requirements compliance
The customer premises equipment complies with the requirements of ITU Recommendation K.21
for resistibility of telecommunication equipment installed in customer premises to over voltage and
overcurrents.
2.3.6 Acoustic noise emission standard compliance
The customer premises equipment complies with EN 300 753 acoustic noise emission limit and test
methods.
Use subject to agreed restrictions on disclosure and use.
24 3FE-49949-AAAA-TCZZA
To Next Page
Loading...
