Configure a Beacon G6
Security configuration
Configuring the IP filter
Figure 7-46 IP filter page
2
Configure the following parameters:
Table 7-33 IP filter parameters
Select the toggle button to enable an IP filter.
Select an IP filter mode from the list:
• Drop for upstream
• Drop for downstream
Select an internal client from the list:
• Custom Settings: uses the IP address input below
• IP: uses the connecting devices' IP to the Beacon
Enter the local IP address.
Enter the local subnet mask.
Enter the remote IP address.
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA 139
To Next Page
Loading...
