Nokia Beacon G6 - Table 7-8 LAN Parameters; Figure 7-13 LAN Page

Configure a Beacon G6
Network configuration
Configuring LAN
Beacon G6
Figure 7-13 LAN page
2
Configure the following LAN parameters:
Table 7-8 LAN parameters
Field
Description
IPv4 address
Enter the IPv4 address of the Beacon.
Subnet mask
Enter the subnet mask of the Beacon.
DHCP enable
Select the toggle button to enable DHCP.
If this toggle button is not enabled, the DHCP functionality cannot be used. you need
not configure DHCP start IP address, DHCP end IP address and DHCP lease time if
this toggle button is not enabled.
Use subject to agreed restrictions on disclosure and use.
82 3FE-49949-AAAA-TCZZA
June 2022
Issue 1