Configure a Beacon G6
Network configuration
Configuring Upstream (US) Classifier
3
Click Add to add a QoS policy.
END OF STEPS
Configuring Upstream (US) Classifier
The US Classifier feature is used to create policies, classifiers, and classifier rules for upstream
traffic handling. This feature is available to admin users (super users) only.
A policy defines an action to be performed on a set of LAN or WAN packets. A policy can be created
at any time and then subsequently assigned to one or more classifiers.
A classifier is used to select key fields for which the classifier rules will be written. A classifier can be
created at any time and then subsequently assigned to one or more classifier rules.
A classifier rule is used to assign actions to a group of packets based on a set of parameters. A
classification rule must be created against a pre-defined classifier.
Up to 16 policies can be created, with up to 8 classifiers and 32 classifier rules.
1
Click Network→ US Classifier in the left pane and select the Policy tab.
All classifier policies are displayed in the policy table in the page.
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA
To Next Page
Loading...
