Nokia Beacon G6 - Configuring UPNP and DLNA; Table 7-29 Port Triggering Parameters

Configure a Beacon G6
Application configuration
Configuring UPNP and DLNA
Beacon G6
2
Configure the following parameters:
Table 7-29 Port triggering parameters
Field
Description
Application name
Select an application name from the list.
The default is Custom settings.
Open port
Enter the open port range.
Triggering port
Enter the triggering port range.
Expire time
Enter the expiration time in seconds.
Allowed range: 1 to 999999 seconds
Open protocol
Select the open port protocol from the list:
• TC P
• UDP
• TCP/UDP
Trigger protocol
Select the triggering port protocol from the list:
• TC P
• UDP
• TCP/UDP
WAN connection list
Select a WAN connection from the list. Only active devices are displayed in the list.
3
Click Save.
END OF STEPS
7.42 Configuring UPNP and DLNA
1
Click Application→ UPNP and DLNA from the left pane. The UPNP and DLNA page displays.
June 2022
Issue 1
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA 133