Configure a Beacon G6
Security configuration
Configuring access control
Table 7-37 Access control parameters (continued)
The following protocols are supported: ICMP, Telnet, SSH, HTTP, TR-069, HTTPS,
SFTP.
Select an access control level for each protocol:
Allow, Deny, or Trusted Network Only
LAN side: Allow or Deny
The following protocols are supported: ICMP, Telnet, SSH, HTTP, TR-069, HTTPS,
SFTP.
Select an access control level for each protocol:
LAN side: Allow or Deny
3
Click Save to save the ACL configuration.
4
If the Enable trusted network option is enabled, add one or more subnet trusted networks.
You can add up to 32 trusted networks.
Table 7-38 Trusted Network parameters
Enter a start IP address range for the new subnet trusted network.
Enter an end IP address range for the new subnet trusted network.
5
Click Add +.
END OF STEPS
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA 155
To Next Page
Loading...
