Configure a Beacon G6
GUI overview
Viewing overview information
Shows the status of the IPTV service. If the IPTV flag is enabled on a routed service, the online or
offline state is indicated by the presence of a WAN IP address for that routed service. If the IPTV is
attached to a bridged service, the online or offline state is defined by the WAN uplink status.
7.5.3 Wi-Fi Networks
Displays a network card per activated single or dual band Wi-Fi network containing the bands
supported, the name of the network and the type of network (bridge or routed).
7.5.4 Connected Clients
Displays the total number of online and offline clients connected to this device (single device or
mesh system).
7.5.5 LAN Interface Status
Displays information about all the LAN ports of the device.
Wi-Fi 2.4GHz
Shows the status of the 2.4GHz (Up/Down) network and the current band setting. This can either be
auto which indicates Radio Resource Management is enabled or in the range 1-13 when manually
configured.
Wi-Fi 5GHz
Shows the status of the 5GHz network (Up/Down) and the current band setting. This can either be
auto which indicates Radio Resource Management is enabled or in the range 36-165 when
manually configured.
Ethernet Ports
Shows the status of the Ethernet ports (Up/Down), the sync rate (10Mbps, 100Mbps, 1Gbps,
2.5Gbps, 5Gbps, 10Gbps) and the duplex mode (Half duplex, Full duplex).
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA 65
To Next Page
Loading...
