Nokia Beacon G6 - Page 89

Configure a Beacon G6
Network configuration
Configuring WAN
Beacon G6
Table 7-11 WAN parameters (continued)
Field
Description
SSID port binding
Select the toggle button next to the SSID to enable it.
Select the toggle button next to the PVID to enable it. This option is not applicable if the VLAN
mode is Tunnel or Transparent.
WAN IP mode
Select an IP mode from the list:
• DHCP
• PPPoE
• Static
Manual DNS
If the selected IP mode is IPv4 and the WAN IP mode is DHCP, enter the Domain Name Server
(DNS) to be configured manually.
IPv4 Address
If the selected IP mode is IPv4 or IPv4&IPv6 and the WAN IP mode is Static, enter the static
IPv4 address.
Netmask
If the selected IP mode is IPv4 or IPv4&IPv6 and the WAN IP mode is Static, enter the netmask.
Gateway
If the selected IP mode is IPv4 or IPv4&IPv6 and the WAN IP mode is Static, enter the gateway
IP address.
Pri DNS
If the selected IP mode is IPv4 or IPv4&IPv6 and the WAN IP mode is Static, enter the primary
Domain Name Server (DNS).
Sec DNS
If the selected IP mode is IPv4 or IPv4&IPv6 and the WAN IP mode is Static, enter the
secondary Domain Name Server (DNS).
Ter DNS
If the selected IP mode is IPv4 or IPv4&IPv6 and the WAN IP mode is Static, enter the tertiary
Domain Name Server (DNS).
Connection trigger
Select the connection trigger type from the list. The default option is Always On.
Username
Enter the username to log in to the configuration server.
This option is applicable only if the WAN IP mode is PPPoE.
Password
Enter the password to log in to the configuration server.
Allowed values are limited to numbers, letters and special characters ! # + , - . / : = @ _.
This option is applicable only if the WAN IP mode is PPPoE.
Keep alive time
The PPPoE connection type triggers one heartbeat each, at the configured time interval to keep
the session online.
Allowed values: 5 to 60 seconds
This option is applicable only if the WAN IP mode is PPPoE.
Keep alive retry
Configure the number of retries to check the Keep Alive status of the PPPoE session after
time-out.
Allowed values: 1 to 10.
This option is applicable only if the WAN IP mode is PPPoE.
Echo value
Indicates the number of times the device sends messages to the server to check if the IP
address is available or not.
This option is applicable only if the WAN IP mode is PPPoE.
June 2022
Issue 1
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA 89