EasyManuals Logo

Nokia N96 Service Manual

Nokia N96
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
General RF troubleshooting
Introduction to RF troubleshooting
Most RF semiconductors are static discharge sensitive
ESD protection must be applied during repair (ground straps and ESD soldering irons).
Pre-baking
These parts are moisture sensitive and must be pre-baked prior to soldering:
RFIC N7505
Front End Module (FEM) N7520
WCDMA PA N7540
Discrete components
In addition to the key-components, there are a number of discrete components (resistors, inductors and
capacitors) for which troubleshooting is done mainly by
visual inspection
.
Capacitors: check for short circuits.
Resistors: check value with an ohm meter.
Note: In-circuit measurements should be evaluated carefully
Measuring equipment
All measurements should be done using:
An oscilloscope for low frequency and DC measurements. Recommended probe: 10:1, 10Mohm//8pF.
A radio communication tester including RF generator and spectrum analyser, for example Rohde & Schwarz
CMU200. (Alternatively a spectrum analyser and an RF generator can be used. Some tests in this guide are
not possible to perform if this solution is chosen).
Note: A mobile phone WCDMA transmitter should never be tested with full TX power (only it possible
to perform the measurements in a good RF-shielded room). Even low power WCDMA transmitters
may disturb nearby WCDMA networks and cause problems to 3G cellular phone communication in
a wide area.
Note: All measurements with an RF coupler should be performed in an RF-shielded environment
because nearby base stations can disturb sensitive receiver measurements. If there is no possibility
to use RF shielded environment, testing at frequencies of nearby base stations should be avoided.
Level of repair
The scope of this guideline is to enable repairs at key-component level. Some key-components are not
accessible, i.e. not replaceable. Please refer to the list of
Non replaceable RF components
.
Note: If the RF shieldning can is removed (for measurement or repair), it must always be replaced
with a new one.
RM-247
RF troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 4 –5
Copyright © 2008 Nokia. All rights reserved.

Table of Contents

Other manuals for Nokia N96

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nokia N96 and is the answer not in the manual?

Nokia N96 Specifications

General IconGeneral
Panel typeTFT
Display diagonal2.8 \
Display resolution240 x 320 pixels
Display number of colors16.78 million colors
Internal memory16 MB
Front camera typeSingle camera
Rear camera resolution2592 x 1944 pixels
USB 2.0 ports quantity1
Multimedia Messaging Service (MMS)Multimedia Messaging Service (MMS) is a standard way to send messages that include multimedia content to and from a mobile phone over a cellular network
Audio formats supportedAAC, eAAC+, MP3, WMA
Image formats supportedEXIF
Ringer typePolyphonic
Form factorSlider
Product colorGray
Talk time (2G)150 h
Battery capacity950 mAh
Standby time (2G)200 h
Continuous audio playback time14 h
Continuous video playback time5 h
2G standardsHSCSD
Data networkwcdma
Bluetooth version2.0+EDR
Weight and Dimensions IconWeight and Dimensions
Depth20 mm
Width55 mm
Height103 mm
Weight125 g

Related product manuals