Nokia N96 Service Manual

RF clock is used by RAPIDOYawe, which provides 19.2MHz SysClk to the application processor. Both
RAPIDOYawe and Nomadik have internal PLL’s that create clock signals for other peripheral devices/interfaces
like SD card, SIM, CCP, I2C and memories.
BT and WLAN have their own 38.4MHz crystal oscillator that generates clock signal when clock request from
either WLAN or BT is high.
32k Sleep Clock is always powered on after startup. Sleep clock is used by RAPIDOYawe and Nomadik
application processor for low power operation. Sleep clock is also used by GPS, FM Radio, Bluetooth and WLAN.
For RAPIDOYawe and GPS the sleep clock is not buffered, for other modules the sleep clock is buffered (VIO_APE
is the buffer power supply).
SMPS Clk is a 2.4MHz clock line from RAPIDOYawe to EM ASIC Betty (N2300) and discrete SMPS N2390. In deep
sleep, when VCTCXO is off, this signal is set to ‘0’ state.
12 MHz Camera Clock is generated by Nomadik.
RM-247
System Module
Issue 1 COMPANY CONFIDENTIAL Page 7 –11
Copyright © 2008 Nokia. All rights reserved.

Nokia N96 Specifications

General

Panel type	TFT
Display diagonal	2.8 \
Display resolution	240 x 320 pixels
Display number of colors	16.78 million colors
Internal memory	16 MB
Front camera type	Single camera
Rear camera resolution	2592 x 1944 pixels
USB 2.0 ports quantity	1
Multimedia Messaging Service (MMS)	Multimedia Messaging Service (MMS) is a standard way to send messages that include multimedia content to and from a mobile phone over a cellular network
Audio formats supported	AAC, eAAC+, MP3, WMA
Image formats supported	EXIF
Ringer type	Polyphonic
Form factor	Slider
Product color	Gray
Talk time (2G)	150 h
Battery capacity	950 mAh
Standby time (2G)	200 h
Continuous audio playback time	14 h
Continuous video playback time	5 h
2G standards	HSCSD
Data network	wcdma
Bluetooth version	2.0+EDR

Weight and Dimensions

Depth	20 mm
Width	55 mm
Height	103 mm
Weight	125 g