Nomadix Access Gateway - Page 218

ACCESS GATEWAY
206 System Administration
4. In the Description field, enter a meaningful description for this port-location assignment.
5. “Provide DHCP Service” is selected by default. De-select this option if you wish to disable
subscriber-side DHCP for this port location. See “Managing the DHCP service options
{DHCP}” on page 112.
6. Enter a Subnet for the port assignment you are adding.
You must now assign a State for this port-location. Possible states are, No Charge for using
this port-location, Charge for Use, and Blocked. If you do not assign a conditional state,
the state is registered as “No Charge” by default.
7. If applicable, select the Default QoS Policy for the port assignment you are adding.
8. Select the conditional state you want to assign to this port-location.
 If you choose Charge for Use additional configurations are available. Refer to the
Note. Port-based Policies should be enabled from the Configuration->AAA page for
these settings to take effect.
 Choose Enable RADIUS Billing if you want RADIUS billing to be enabled on this
port.
 Choose Enable Tunneling if you want L2TP Tunneling based billing to be enabled on
this port.
 Choose Enable PMS Billing if you want PMS based room billing to be enabled on
this port.
 Choose Enable Credit Card Billing if you want Credit Card based billing to be
enabled on this port
You can select any number of billing methods per port.
A specific billing plan can be assigned to a port or all the existing billing plans defined on
the NSE can be enabled on the port. Please select the appropriate option from the
dropdown list for
Billing Plan(s) available on port.
Please note that while it is possible to set the value of a per-port configuration parameter
independently of the value of the corresponding global parameter, the feature itself is
disabled for a port unless both the per-port and global parameters are set to enabled. Thus:
 RADIUS authentication for a port is enabled only if the RADIUS Client is globally
enabled AND the per-port enable RADIUS billing parameter is set.
 Credit card billing for a port is enabled only if Credit Card Services is globally
enabled AND the per-port enable Credit Card billing parameter is set.
 PMS billing for a port is enabled only if PMS Services is globally enabled AND the
per-port enable PMS billing parameter is set.
 Tunneling for a port is enabled only if Tunneling is globally enabled AND the per-
port enable Tunneling parameter is set.