Maintenance
5-2
Part 1108061-02
E 2015 Nordson Corporation
Daily Maintenance
Perform these procedures daily to keep your system clean and functioning
properly.
NOTE: It is important that the inside surface of the canopy is not touched
by bare hands. Skin oils and other contaminants will affect the ability of the
canopy to shed powder during blowoff. Operators should wear cotton
gloves when working with the canopy.
System Cleaning
Perform this procedure daily.
WARNING: Wear an approved respirator and safety glasses or goggles
when performing maintenance or cleaning operations. Obtain and read
Material Safety Data Sheets for each powder used.
1. Perform all color change procedures in the Operation section.
2. Clean the spray guns according to the instructions in their manuals.
NOTE: Do not scratch the interior surfaces of the canopy or touch them
with bare hands. Wear clean cotton gloves when cleaning the interior.
3. Remove any powder residue from the canopy using an air-powered
vacuum with a soft brush attachment. Wipe down all surfaces with a
damp, lint-free cotton cloths (do not use tack cloths).
4. Clean the floor around the booth.
To Next Page
Loading...
