Repair
7-2
Part 1108061-02
E 2015 Nordson Corporation
Cartridge Filter Installation
See Figure 7-1.
1. Thoroughly clean the sealing surface on the underside of the mounting
plate (7). A dirty surface will prevent the cartridge filter gasket from
sealing properly and allow powder to leak into the fan section.
2. Remove the new cartridge filter (10) from its carton and inspect it for
damage. Do not use damaged cartridge filters.
3. Set the centering bracket (9) into the open end of the new cartridge filter.
Slide the draw rod (8) through the centering bracket and screw the draw
rod into the bottom of the cartridge filter.
4. Center the cartridge filter under the opening in the mounting plate. Use
the draw rod’s T-handle to pull up the cartridge filter against the
mounting plate.
5. Install the mounting bracket (6) on the draw rod, making sure that the
slots in the mounting bracket slip over the T-handle.
6. Install the flat washer (5), lock washer (4), and nut (3) onto the draw rod.
Do not tighten the nut at this time.
7. Slip the ends of the mounting bracket into the locating slots around the
filter opening in the mounting plate.
8. Tighten the nut until the mounting and centering brackets are touching.
This will compress the filter gasket (11) and seal the cartridge against
the mounting plate.
9. When all filters have been replaced, inspect the access door gaskets for
damage. Replace any damaged gaskets. Install the access doors.
To Next Page
Loading...
