Nordson ColorMax - Procedure 4: Gun Purge and Lance Movement - Operator B; Initiate Gun Purge; Blow Off Lance Assembly During Purge; Lance Assembly Raises Upon Purge Completion

Table of Contents
iv
Part 1108061-02
E 2015 Nordson Corporation
Operation 4-1..............................................
Introduction 4-1.............................................
New System Preparation 4-1.................................
Canopy Conditioning 4-1..................................
Cartridge Filter Seasoning 4-1..............................
Main System Panel Controls 4-1..............................
System Start/Stop Pushbuttons 4-2.........................
Main Menu 4-2...........................................
Screen Access 4-3.......................................
System Control Menu 4-3.................................
System Control Screen 4-4................................
Manual Motor Control 4-5.................................
Color Change Status 4-6..................................
Alarm Acknowledge/Clear 4-7..............................
Alarms 4-8..............................................
Alarm Log 4-8............................................
Typical Operating Settings 4-9................................
Operating Air Pressures 4-9................................
AfterFilter Pulse Timer Board Settings 4-9....................
Typical Blow-off Settings 4-9...............................
Startup 4-10.................................................
Feed Center Controls 4-12..................................
Color Change Procedure 4-13.................................
Conditions for an Effective Color Change 4-13.................
Color Change Process Monitoring 4-13.......................
Color Change Procedure 4-14...............................
Shutdown 4-16...............................................
Maintenance 5-1...........................................
Initial Canopy Conditioning 5-1...............................
Daily Maintenance 5-2.......................................
System Cleaning 5-2......................................
Daily Equipment Maintenance 5-3...........................
Weekly Maintenance 5-4.....................................
Monthly Maintenance 5-4.....................................
Booth Canopy Conditioning 5-5...............................
Cyclone Cleaning 5-5.......................................
Emptying Afterfilter Waste Hopper 5-6.........................
Maintenance Check List 5-8..................................
Troubleshooting 6-1........................................
Common Problems 6-1......................................
Alarm Messages 6-6.........................................
Clearing Alarms 6-6.......................................
Reversing Motor Direction 6-7.................................
Repair 7-1.................................................
Introduction 7-1.............................................
Cartridge Filter Replacement 7-1..............................
Cartridge Filter Removal 7-1...............................
Cartridge Filter Installation 7-2.............................
Cartridge Filter Seasoning 7-4..............................
Final Filter Replacement 7-5.................................
Pulse Valve Replacement 7-6................................
Preparation
7-6...........................................
Afterfilter Fluidizing Plate Replacement 7-7.....................