Nortel BCM50a - Page 255

Appendix G Command Interpreter 255
BCM50a Integrated Router Configuration — Advanced
srv
Records the most heavily used protocols or
service ports.
stroute
display [rule # | buf]
Displays the list of static routes or detailed
information on a specified rule.
load <rule #>
Loads the specified static route rule into the
buffer.
save
Saves a rule from the buffer to the System
Parameters Table.
config
name <site name>
Sets the name for a static route.
destination <dest
addr>[/<bits>]
<gateway>
[<metric>]
Sets a static route’s destination IP address
and gateway.
mask <IP subnet
mask>
Sets a static route’s subnet mask.
gateway <IP
address>
Sets a static route’s gateway IP address.
metric <metric #>
Sets a static route’s metric number.
private <yes|no>
Turns private mode on or off.
active <yes|no>
Enables or disables a static route rule.
dropIcmp [0|1]
Sets whether or not the device allows ICMP
fragment packets.
igmp
debug [level]
Sets IGMP debug level.
forwardall [on|off]
Activates or deactivates IGMP forwarding to
all interfaces flag.
querier [on|off]
Turns on or off IGMP stop query flag.
iface
<iface> grouptm
<timeout>
Sets IGMP group timeout for the specified
interface.
<iface> interval
<interval>
Sets IGMP query interval for the specified
interface.
<iface> join
<group>
Adds an interface to a group.
Table 59 IP commands
Command Description