NSK MEGATORQUE M-ESA-Y2005V25 - Position Scale Reset; Example of Position Scale Setting

— 9-25 —
9.2.1.4. Position Scale Reset
Caution : • The position scale value is not decided immediately after the power is turned
on. Be sure to reset the position scale before positioning.
• The position scale value is reset to 0 by the following operations.
◊ Home Return completion
◊ AZ command input
9.2.1.5. Example of Position Scale Setting
1 Set the CCW direction of the position scale as the plus direction.
1) Input the password.
The password acknowledgment message appears on the display.
:
:/NSK ON
NSK ON
:_
N S/
SP
K
N
ENT
O
2) Input the DI command to determine the position scale direction.
:/NSK ON
NSK ON
:DI1
:_
ENT
I 1
#
D
2 Setting the linear position scale
1) Input the password.
The password acknowledgment message appears on the display.
:
:/NSK ON
NSK ON
:_
N S/
SP
K
N
ENT
O
2) Input the PS command to determine the type of position scale.
:/NSK ON
NSK ON
:PS0
:_
ENT
S 0
?
P
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com