— 9-39 —
9.3.3. Communication with Personal Computer
l This section describes how to store the parameters of Driver Unit using HyperTerminal of
communication software which is provided with Windows 95 as standard.
l The user shall provide the communication cable. Pin-out of the D-sub 9pins connector of ESA
Driver Unit is different from DOS/V machine. Refer to “5.1. CN1: RS-232C Serial Communication
Connector” and the manual of the personal computer.
9.3.3.1. Set-up of HyperTerminal
1) Start HyperTerminal.
[ (Start menu) → (Program) → (Accessory) → (HyperTerminal) ]
2) Dialog of “Setting of connection” is displayed.
Declare the name of connection and set an icon, then press [OK] button.
3) Dialog of “Telephone-number” is displayed.
Select “Direct to Com#” in “the way of connection N,” then press [OK] button.
4) Dialog box of “Property of Com#” is displayed.
Follow the table bellow for input, then press [OK] button.
Table 9-14
Bit/sec. 9 600
Data bit (D) 8
Parity (P) None
Stop bit (S) 2
Flow control (F) Hardware
5) Select the menu “File (F)” → “Property (P).”
Dialog of “Property of xxxx” is shown in the display.
[xxxx is the name of connection declared in the procedure 1).]
6) End of HyperTerminal.
The dialog box stating “Do you store the session xxxx ?” is displayed.
Press [Yes (Y)] button and store the session. Use the session to communicate with ESA
Driver Unit afterwards.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...