NSK MEGATORQUE M-ESA-Y2005V25 - Canceling Command; Error

— 7-3 —
7.2.2. Canceling Command
l To cancel a command which has been entered halfway, enter a backspace code.
l For example, when the backspace code is input following VG0.5, the cursor moves one space back
to the position where 5 was input and thereby deletes 5.
Figure 7-3 : Canceling Example
:VG0._:VG0.5_
Input
BS
Key
Input (To Driver Unit)
.
=
G 0
?
V 5
%
BS
7.2.3. Error
l Note that an error occurs in any of the following cases:
1) If a nonexistent command (i.e., character string) is entered.
(If an entered character string cannot be decoded.)
2) If data or subscript out of the allowable range is entered.
3) If a command requiring the password is entered without the password.
l In any of these cases, the entered character string with a “?” mark is returned as an error message.
For example,
Figure 7-4 : Input Error Example 1
:ABCDE
ABCDE?
:_
Input (To Driver Unit)
DB CA E
ENT
If ABCDE is entered, an error message is returned
since this character string is not a command.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com