NSK MEGATORQUE M-ESA-Y2005V25 - Entering Parameter; Parameter that Requires Entry of Password

— 7-4 —
7.2.4. Entering Parameter
1) When entering parameter, make sure that a colon ( : ) is displayed on the screen.
( If the colon is not displayed, press the enter key once.)
:_
ENT
2) As an example, set the parameter “Move Velocity MV” (revolution speed) to 0.5 r.p.s.
Enter the parameter as shown below.
:MV0.5
:_
.
=
V 0
?
M
ENT
5
%
The colon ( : ) appears to confirm the entry.
l As shown above, inputting “the parameter command + numeric value + ENT key” completes the
parameter entry. (Entering the space key between the parameter and numeric values is not
necessary.)
7.2.5. Parameter That Requires Entry of Password
1) When entering the command, make sure that a colon ( : ) is displayed on the screen.
(If the colon is not displayed, press the enter key once.)
:_
ENT
2) Enter the password referring to “7.2.1. Password.”
:/NSK ON
NSK ON
:_
KN S/
SP
N
ENT
O
The message confirming the entry of password is displayed and the colon ( : ) appears on the
screen.
3) Enter the parameter as described in “7.2.4. Entering Parameter” above.
The parameters which requires entry of the password may only be executed immediately after the
password is inputted.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com