Maintenance 159
3 Take the paper out of the pack. In case of wrapped paper, remove the top and
bottom sheets.
4 Hold each pack of paper at the two short sides and bend it slightly. Then place
it in the tray.
5 If you are filling paper tray 1, slide the two guides against the sides of the
paper, as in figure 92. Make sure that the paper is loaded in the right feed
direction (portrait or landscape).
[92] Adjusting the slides in paper tray 1.
Note: Pre-printed and punched paper must be placed face up, with the top
of the page in the direction shown in figure 35 on page 63.
6 Push the tray back into place.
7 Repeat for other paper trays, as necessary.
8 Close the door to the paper tray compartment.
1
2
3
To Next Page
Loading...
