Oce 3165 - Page 21

Introduction 21
set all settings to their standard value the first time. We recommend that you
press this button twice before copying as this insures that the standard values
are active.
When operating the Océ 3165 Network Copier, the key operator can also
preset whether the machine is mainly used for printing or for copying. If you
press the correction button a third time, the machine switches to its initial
mode, which can be ‘Printing’ or ‘Copying’.
The correction button can also be used to delay a print job in order to make a
copy job in between (see ‘Claiming the Océ 3165 Network Copier’ on
page 31).
Stop button The red button above the correction button with the symbol
‘ ’ is used to stop a job that is being printed. You can indicate whether to stop
after the current set is finished (by pressing the stop button once) or to stop
immediately (by pressing the stop button twice). Before the job is cancelled
definitively and the data is erased, the copier will ask for confirmation. The
stop button thus affects the execution phase of a copy or print job.
When printing pages stops, the scanning of originals will not stop. If the job
being printed is a copy job, and the stopping of the job is confirmed by pressing
the start button, then also the scanning stops and all scanned pages are deleted.
Arrow buttons The arrow buttons , , and , which are grouped in the
form of a star to the right of the display, are used to choose settings. If these
buttons can be used, this will be indicated in the display.
Note: The two buttons to the left of the display are not in use yet. These buttons
will be used in a later release.