Oki MICROLINE MX Series - Page 383

Index
383
PAP UNEXP INT *, 334
PARAMETER ERROR, 334
PARITY ERROR, 334
PLAT INV CMD *, 334
PLAT INV PARM *, 334
PLAT INV STATE *, 334
PLEASE WAIT...RESET IN
PROGRESS, 335
POWER SAVER MODE, 335
POWERSUPPLY HOT *, 335
PRINTER HOT *, 335
PRINTER UNDER REMOTE
CONTROL, 335
PROTECTED INSTR *, 336
PWRSUPP VOLT *, 336
QUEUE OVERRUN*, 336
RBN AT END POINT, 337
RBN SENSOR ERROR, 336
REMOVE USED SPX, 336
RESTORING BOOT CODE, 336
RIB INVLD CMD*, 336
RIB INVLD STATE*, 337
RIBBON DRIVE, 337
RIBBON NOT RECOGNIZED, 337
RIBBON STALL, 337
RIBBON UNDER 2%, 337
SCS COMMAND ERROR, 337
SECURITY KEY NOT
DETECTED, 338
SECURITY VIOLATION, 337
SENDING PROGRAM TO EC
PROCESSOR, 338
SHUTL INV CMD *, 338
SHUTL INV PARM *, 338
SHUTL OVR SPEED*, 338
SHUTTLE JAM, 338
SHUTTLE STALL, 339
SOFTWARE ERROR* CYCLE
POWER, 339
SPX FOUND, ERROR KEY NOT
DETECTED, 339
SPX NOT NEEDED OPTIONS
ENABLED, 339
SSTACKER JAM, 340
STACK OVERFLOW*, 339
STACK UNDERFLOW*, 339
STACKER FAULT, 340
STACKER FULL, 340
TABLE MISMATCH DOWNLOAD
AGAIN, 340
TCB CORRUPTED*, 340
TCP PORT BUSY, 340
UNDEF INTERRUPT*, 341
UNDFNED OPCODE*, 341
UNKNOWN RBN1, 341
UNKNOWN RBN2, 341
UP DRV. SHORT*, 341
WAITING FOR ETHERNET
ADAPTER, 341
Fault, Centronics Parallel Interface
Signals, 295
Features, printer, 11
FF After Job, 175, 192