Omron 3G3MX2-A2002-EV2 - Page 229

5 Basic Settings
5 - 27
Multi-function Compact Inverter 3G3MX2-EV2 User’s Manual (I666-E1)
5-5 Frequency Reference Settings
5-5-1 Frequency Reference Selection
To switch between the analog voltage and analog current inputs to set the frequency reference, set the
parameters as shown in the table below.
This enables switching between the frequency reference input (voltage reference) and frequency refer-
ence input (current reference) terminals.
To switch between these analog input signals, use the terminal AT (Analog input switching) allocated to
a multi-function input terminal.
When the terminal AT is input, the frequency reference input (current reference) terminal is enabled.
• Frequency reference input (Voltage reference), between O and L: 0 to 10 VDC
• Frequency reference input (Current reference), between OI and L: 4 to 20 mA
Note By default, each analog input signal is set to reach the maximum frequency at 9.8 V or 19.8 mA.
To switch between an analog voltage input and the volume control on the Digital Operator (Model:
3G3AX-OP01) to set the frequency reference, set the parameters as shown in the table below.
This enables switching between the frequency reference input (voltage reference) and the volume con-
trol on the 3G3AX-OP01.
To switch the reference input, use the terminal AT (Analog input switching) allocated to a multi-function
input terminal.
When the terminal AT is input, the volume control on Digital Operator (Model: 3G3AX-OP01) is
enabled.
• Frequency reference input (Voltage reference), between O and L: 0 to 10 VDC
• Volume control on Digital Operator (Model: 3G3AX-OP01)
Note By default, each analog input signal is set to reach the maximum frequency at 9.8 V or 19.8 mA.
Parameter No.
Function name
Data
Default data
Unit
A001/A201
1st/2nd Frequency
Reference Selection
01: Control circuit terminal block
(Analog input)
02
−
A005
O/OI Selection
02: Switch between O (Voltage)
and volume via terminal AT
(Enabled only when
3G3AX-OP01 is used.)
00
−
C001 to C007
Multi-function Input
1 to 7 Selection
16: AT (Analog input switching)
−
−
Using an Analog Voltage Input or Analog Current Input by Switching
Parameter No.
Function name
Data
Default data
Unit
A001/A201
1st/2nd Frequency
Reference Selection
01: Control circuit terminal block
(Analog input)
02
−
A005
O/FI Selection
00: Switch between O (Voltage)
and FI (Current)
00
−
C001 to C007
Multi-function Input
1 to 7 Selection
16: AT (Analog input switching)
−
−
5
V
A
Using an Analog Voltage Input and Volume Control by Switching
V