Omron 3G3MX2-A2002-EV2 - STOP Key Selection

5 Basic Settings
5 - 41
Multi-function Compact Inverter 3G3MX2-EV2 User’s Manual (I666-E1)
5-7-3 STOP Key Selection
• Enable/disable the STOP/RESET key on the Digital Operator.
• This setting is enabled when the 1st/2nd RUN Command Selection (A002/A202) is not set to 02 (Dig-
ital Operator).
However, when the 1st/2nd RUN Command Selection (A002/A202) is set to 02 (Digital Operator), the
STOP/RESET key is enabled independent of this setting.
The STOP/RESET key on the Digital Operator is enabled only when the STOP Key Selection
(b087) is set to 00: Enabled (default data).
Be sure to provide a separate emergency stop switch.
5
5-7 Stop Method Settings
5-7-3 STOP Key Selection
Parameter
No.
Function name
Data
Default
data
Unit
b087
STOP Key Selection
00: Enabled
01: Disabled
02: Only RESET enabled
00
−
Data
STOP command via STOP/RESET key on
Digital Operator
Trip reset via STOP/RESET key on
Digital Operator
00
Enabled
Enabled
01
Disabled
Disabled
02
Disabled
Enabled
Precautions for Safe Use