6 Vector Control and Applied Functions
Multi-function Compact Inverter 3G3MX2-EV2 User’s Manual (I666-E1)
The following parameter selection functions are not available and therefore not displayed on the Digital
Operator.
Unavailable selection functions
Power Interruption/Undervoltage
Restart Selection
Frequency pull-in restart
Overvoltage/Overcurrent Restart
Selection
Frequency pull-in restart
Frequency pull-in restart
Multi-function Input 1 Selection
06:
08:
14:
40:
41:
42:
44:
46:
47:
52:
66:
67:
68:
69:
70:
73:
85:
91:
JG (Jogging)
SET (2nd control)
CS (Commercial switching)
TL (Torque limit enabled)
TRQ1 (Torque limit switching 1)
TRQ2 (Torque limit switching 2)
BOK (Brake confirmation)
LAC (LAD cancel)
PCLR (Current position clear)
ATR (Torque reference input permission)
CP1 (Position command selection 1)
CP2 (Position command selection 2)
CP3 (Position command selection 3)
ORL (Origin search limit signal)
ORG (Origin search start signal)
SPD (Speed/Position switching)
EB (Rotation direction detection)
PSET (Preset current position)
Multi-function Input 2 Selection
Multi-function Input 3 Selection
Multi-function Input 4 Selection
Multi-function Input 5 Selection
Multi-function Input 6 Selection
Multi-function Input 7 Selection
Multi-function Output 11 Selection
OTQ (Overtorque/Undertorque signal)
TRQ (Torque limit)
Multi-function Output 12 Selection
DSE (Excessive speed deviation)
Multi-function Relay Output (AL1,
AL2) Function Selection
POK (Position ready)
SETM (Motor 2 selection)
Output torque (Only in the sensorless vector control)
Output torque (Only in the sensorless vector control)
Output torque (signed) (Only in the sensorless vec-
tor control)
Frequency pull-in restart
Pulse Train Input EA Selection
Frequency setting (including PID)
Unavailable Selection Functions
6-8-2 Functional Limitations in PM Motor Mode
To Next Page
Loading...