148
C-mode Command Details Section 4-3
End Codes There are no end codes with this command. (There is no response).
If the ABORT command (XZ) is received when data is being sent from a serial
port to a host, the send operation will be stopped even in the middle of a
frame.
4-3-38 INITIALIZE – – **
Initializes the transmission control procedure of the Units at all the unit num-
bers.
Command Format
Limitations Multiple responses to a command can be cancelled with this command.
The INITIALIZE command does not receive a response.
End Codes There are no end codes with this command. (There is no response).
4-3-39 Undefined Command – – IC
This response is returned if the header code of a command cannot be
decoded.
Response Format
Limitations This response will be returned as an error for illegal header codes.
This response will be returned for error frames as well.
There is no command associated with IC.
End Codes There are no end codes with this command.
↵
@
*
*
@ I C
x 10
0
x 10
1
↵*
Unit No. (BCD)
Header
code
TerminatorFCS
To Next Page
Loading...
Need help?
General
