Omron CJ - REFERENCE MANUAL 07-2009 User Manual

189
FINS Commands Section 5-3
Execution Conditions
Command Format
Response Format
Parameters Program number (command)
Always FFFF (hex).
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
Comments If the CPU Unit’s operating mode has already been changed to the intended
mode when this command is sent, a normal completion will be returned.
If only the command code or only the command code and program number
are to be sent, the operating mode will be changed to the PROGRAM mode.
5-3-15 CPU UNIT DATA READ: 05 01
Reads the following data:
• CPU Unit model
• CPU Bus Unit configuration
• CPU Unit internal system version
• Remote I/O data
• Area data
• CPU Unit information
Execution Conditions
Command Format
Access right at
other device
UM read
protection
DIP switch UM write
protection
Network write
protection
No OK OK No
RUN mode MONITOR mode PROGRAM mode
OK OK OK
Command
code
02
04
Program
No.
FFFF
0204
End codeCommand
code
Access right at
other device
UM read
protection
DIP switch UM
write protection
Network write
protection
OK OK OK OK
RUN mode MONITOR mode PROGRAM mode
OK OK OK
Command
code
01
05
Data

Omron CJ - REFERENCE MANUAL 07-2009 Specifications

General

Brand	Omron
Model	CJ - REFERENCE MANUAL 07-2009
Category	Computer Hardware
Language	English