218
FINS Commands Section 5-3
Command Format
Response Format
Parameters Disk number (command)
The classification of the file memory with the file to be deleted is specified as
follows:
8000 (hex): Memory card
8001 (hex): EM file memory
Number of files (command)
Specify the number of files to be deleted.
File name (command)
Specify the name of the file to be deleted. For details on the configuration,
refer to page 168.
Directory length
Indicates the length of the absolute directory path. The maximum number of
characters is 65. To specify the root directory as the absolute directory path,
specify 0000 (hex) as the directory length.
Absolute directory path
Indicates the absolute path from the root directory. It begins with \ (5C hex),
and the drive name and colon (:) are not required. “\” is used to delimit the
lower directory. It is not required at the end of the final absolute path. No set-
ting is required to specify the root directory itself.
Number of files (response)
Indicates the number of files actually deleted.
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
Comments The specified files will be deleted in sequence. If non-existing file names have
been specified, the PLC will ignore them and the operation will continue.
5-3-37 FILE COPY: 22 07
Copies a file from one file memory to another file memory connected to the
same CPU Unit.
Execution Conditions
Disk No.Command
code
22
05
No. of
files
File name File name
12 bytes
12 bytes
Directory
length
Absolute directory
path
End codeCommand
code
22
05
No. of
files
Access right at
other device
UM read
protection
DIP switch UM write
protection
Network write
protection
No OK OK No
RUN mode MONITOR mode PROGRAM mode
OK OK OK
To Next Page
Loading...
Need help?
General
