195
FINS Commands Section 5-3
MSG(195), execute MESSAGE READ (command code 0920). Refer to 5-3-21
MESSAGE READ: 09 20.
Error code (response)
Among errors that occur when the command is executed, the error code indi-
cates the most serious. If there are no errors, it will be 0000 (hex).
Error message (response)
Indicates messages from execution of FAL(006) or FALS(007). If there is no
error message, or if FAL(006) or FALS(007) are not being executed, 16
spaces (ASCII 20) will be returned.
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
Comments To read the error log, read the appropriate Auxiliary Area words or execute
ERROR LOG READ command (command code 2102). Refer to 5-3-28
ERROR LOG READ: 21 02.
5-3-18 CYCLE TIME READ: 06 20
Initializes the PLC’s cycle time history or reads the average, maximum, and
minimum cycle time.
Execution Conditions
Command Format
Response Format The response format is as follows when the parameter is 00 hex:
15 876543210
0 0
Always 0.
Bit
Message No. 0 (0: no/1: yes)
Message No. 1 (0: no/1: yes)
Message No. 2 (0: no/1: yes)
Message No. 3 (0: no/1: yes)
Message No. 4 (0: no/1: yes)
Message No. 5 (0: no/1: yes)
Message No. 6 (0: no/1: yes)
Message No. 7 (0: no/1: yes)
Second byteFirst byte
Access right at
other device
UM read
protection
DIP switch UM
write protection
Network write
protection
OK OK OK OK
RUN mode MONITOR mode PROGRAM mode
OK OK No
2006
Command
code
Parameter
2006
End codeCommand
code
To Next Page
Loading...
Need help?
General
