219
FINS Commands Section 5-3
Command Format
Response Format
Parameters Disk number (command)
The classification of the copy source and copy destination file memory is
specified as follows:
8000 (hex): Memory card
8001 (hex): EM file memory
File name (command)
Specify the file to be copied and a new name for the copy destination file.
Directory length
Indicates the length of the absolute directory path. The maximum number of
characters is 65. To specify the root directory as the absolute directory path,
specify 0000 (hex) as the directory length.
Copy source and copy destination absolute directory path
Indicates the absolute path from the root directory. It begins with \ (5C hex),
and the drive name and colon (:) are not required. “\” is used to delimit the
lower directory. It is not required at the end of the final absolute path. No set-
ting is required to specify the root directory itself.
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
Comments The file will not be copied if there is already a file of the same name at the
destination.
The file will not be copied if an existing file name is given at the copy destina-
tion.
The copy destination file is given the same date as the copy source file.
5-3-38 FILE NAME CHANGE: 22 08
Changes a registered file name.
Execution Conditions
Disk No.Command
code
22
07
File name Disk No. File name
Source Destination
12 bytes
12 bytes
Directory
length
Copy source
absolute di-
rectory path
Directory
length
Copy destination
absolute directory
path
End code
Command
code
22 07
Access right at
other device
UM read
protection
DIP switch UM write
protection
Network write
protection
No OK OK No
RUN mode MONITOR mode PROGRAM mode
OK OK OK
To Next Page
Loading...
Need help?
General
