Omron CJ - REFERENCE MANUAL 07-2009 User Manual

205
FINS Commands Section 5-3
If this command is executed when another device holds the access right, any
processing being executed by that other device will be aborted. If possible,
wait until all processing has been completed and then execute ACCESS
RIGHT ACQUIRE (command code 0C01). (Refer to 5-3-24 ACCESS RIGHT
ACQUIRE: 0C 01.)
When the access right is forcibly acquired by this command, the device losing
the access right is not notified.
5-3-26 ACCESS RIGHT RELEASE: 0C 03
Releases the access right regardless of what device holds it.
Execution Conditions
Command Format
Response Format
Parameters Program number (command)
Always FFFF (hex).
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
Comments The access right can be released by this command even when the access
right is held by another device. In that case a normal end code will be
returned. A normal end code will also be returned if this command is used
when the access right is already released.
220A MEMORY AREA–FILE TRANSFER
(I/O memory to file transfers only)
No
220B PARAMETER AREA–FILE TRANSFER No
220C PROGRAM AREA–FILE TRANSFER No
2215 CREATE/DELETE DIRECTORY No
2220 MEMORY CASSETTE TRANSFER No
2301 FORCED SET/RESET Yes
2302 FORCED SET/RESET CANCEL Yes
Command
code
Command name Command execution
while another device
has access right
Access right at
other device
UM read
protection
DIP switch UM
write protection
Network write
protection
OK OK OK OK
RUN mode MONITOR mode PROGRAM mode
OK OK OK
Command
code
03
0C
Program
No.
FF FF
030C
Command
code
End code

Omron CJ - REFERENCE MANUAL 07-2009 Specifications

General

Brand	Omron
Model	CJ - REFERENCE MANUAL 07-2009
Category	Computer Hardware
Language	English