151
Command Lists Section 5-1
FINS write access
log
21 40 FINS WRITE ACCESS LOG READ The CPU Unit automatically keeps a log
of any access for FINS write commands.
This command reads this log.
21 41 FINS WRITE ACCESS LOG CLEAR
(See note.)
Clears the FINS write access log.
File memory 22 01 FILE NAME READ Reads file memory data.
22 02 SINGLE FILE READ Reads a specified length of file data
from a specified position within a single
file.
22 03 SINGLE FILE WRITE (See note.) Writes a specified length of file data
from a specified position within a single
file.
22 04 FILE MEMORY FORMAT (See note.) Formats (initializes) the file memory.
22 05 FILE DELETE (See note.) Deletes specified files stored in the file
memory.
22 07 FILE COPY (See note.) Copies files from one file memory to
another file memory in the same
system.
22 08 FILE NAME CHANGE (See note.) Changes a file name.
22 0A MEMORY AREA–FILE TRANSFER
(See note.)
Transfers or compares data between the
I/O memory area and the file memory.
22 0B PARAMETER AREA–FILE TRANSFER
(See note.)
Transfers or compares data between the
parameter area and the file memory.
22 0C PROGRAM AREA–FILE TRANSFER
(See note.)
Transfers or compares data between the
UM (User Memory) area and the file
memory.
22 15 DIRECTORY CREATE/DELETE (See
note.)
Creates or deletes a directory.
22 20 MEMORY CASSETTE TRANSFER
(CP1H CPU Units, CP1L CPU Units
only)
Transfers and verifies data between a
Memory Cassette and the CPU Unit.
Debugging 23 01 FORCED SET/RESET (See note.) Force-sets or force-resets bits, or
releases force-set status.
23 02 FORCED SET/RESET CANCEL (See
note.)
Cancels all bits that have been force-set
or force-reset.
Serial Gateway
functions
28 03 CONVERT TO COMPOWAY/F COM-
MAND
Encapsulates a CompoWay/F command
in a FINS command and sends it to a
serial port. (The CompoWay/F com-
mand is extracted and sent through the
serial port at the receiving end.)
28 04 CONVERT TO MODBUS-RTU COM-
MAND
Encapsulates a Modbus-RTU command
in a FINS command and sends it to a
serial port. (The Modbus-RTU com-
mand is extracted and sent through the
serial port at the receiving end.)
28 05 CONVERT TO MODBUS-ASCII COM-
MAND
Encapsulates a Modbus-ASCII com-
mand in a FINS command and sends it
to a serial port. (The Modbus-ASCII
command is extracted and sent through
the serial port at the receiving end.)
Any Any CONVERT TO HOST LINK FINS COM-
MAND (See note 2.)
Sends any FINS command to a PLC
connected to the serial port of a Serial
Communications Board or Unit (Ver. 1.2
or later only).
Type Command
code
Name Function
MR SR
To Next Page
Loading...
Need help?
General
