187
FINS Commands Section 5-3
Command Format
Response Format
Parameters Program No. (command)
Set to FFFF (hex).
Clear code (command)
Without interrupt tasks: 00 (hex)
With interrupt tasks: 10 (hex)
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
Comments The program area can be cleared even if it is read-protected from a Program-
ming Device. When the program area is cleared, protection will also be
cleared.
Without Interrupt Tasks
In this mode, only one single cyclic task 0 is set up.
With Interrupt Tasks
In this mode, one single cyclic task 0 and one or several interrupt tasks are set
up.
Note Interrupt tasks and cyclic tasks contain only one END(001) instruction after
execution.
When the "Prohibit from overwriting to a protected program" setting is
enabled, this command cannot be executed.
0803 FF FF
Program
No.
Command
code
Clear code
0803
End codeCommand
code
Name Number Task No.
Power interrupt task 0 ---
Scheduled interrupt task 0 ---
I/O interrupt task 0 ---
Cyclic task 1 0
Name Number Task No.
Power interrupt task 1 1
Scheduled interrupt task 2 2
3
I/O interrupt task 32 100
.
.
131
Cyclic task 1 0
To Next Page
Loading...
