EasyManuals Logo

Omron CJ - REFERENCE MANUAL 07-2009 User Manual

Omron CJ - REFERENCE MANUAL 07-2009
267 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #264 background imageLoading...
Page #264 background image
242
Revision History
06 August 2002
“PC” was changed to “PLC” throughout the manual in the sense of “Programmable Controller.
CJ1M CPU Units and new versions of Serial Communications Units/Boards were added.
Page 28: Description of GCT changed.
Page 35: Note added.
Page 125: Information added following table.
07 May 2003 Changes were made throughout the manual to include information for new products
(CS1D-CPU@@H and CJ1G/H-CPU@@EV1).
Page ix: Table updated to correct catalog numbers and add new catalogs.
Page xiii: A caution added regarding back up information.
Page xiv: Corrected “CJ Series CPU Units” to “CJ1, CJI-H, CJ1M, or CS1D CPU Units.
Page xv: A caution added regarding operating differences between CS1 and CJ1, CJI-H,
CJ1M, or CS1D CPU Units when using factory settings.
Page 22: Table corrected to include new CS/CJ-series models.
Page 30 “00 0A Hex” for first read address in graphic corrected to “0A 00 Hex.
Page 55: Order of steps 9 and 10 corrected in graphic.
Page 93: “Bit 1” corrected to “Bit 0” in graphic of response format.
Page 113: Note on flags in end code added.
Page 119, 120: Information on flags in end codes and handling errors changed.
Page 132: “00” corrected to “---” in CV mode memory area code column for CIO Area and
AR Area.
Page 150: Information on operating status parameters updated for new models.
Page 151: “Reserved for system” changed to “1: Duplex error” in bit 14 of non-fatal error
data response.
Page 163: Table of error codes updated for new models.
08 December 2003 Pages xi to xvii: PLP information updated.
Front of manual: Information added on unit versions.
Pages 4, 5, 110, and 111: Note and references to it added and 21 40 and 21 41 added.
Pages 24 and 28: Note added.
Page 45: Information on destination unit address changed.
Page 55: Addresses corrected in program
Page 110:
Pages 111 to 113: Column added and 21 40 and 21 41 added.
Pages 146 and 167: “Version” changed to “internal system version.
Page 163: “FFFF” added to table.
Page 166: Sections added on 21 40 and 21 41.
09 August 2004 “CompoBus/D” was changed to “DeviceNet” throughout the manual.
Pages 8, 38, and 111: Notes added.
Page 15: Section 2-4 replaced.
Page 24: Note changed.
Page 28: Description of ICV and RSV changed.
Pages 28, 29, 41, 49, and 50: Information on GCT changed.
Pages 28, 29, 31, 40, 45, 46, and 48: Information added on new Ethernet Units and other
settings changed.
Page 33: Information on unit addresses added.
Page 34: Graphic changed.
Page 35: Values for gateway count changed.
Pages 39, 41, 44, 45, 47, 49, and 50: Values of GCT/RSV changed.
Page 41: Description of RSV changed.
Page 58: Section added.
Page 70: Status definitions added to graphic.
Pages 111 and 113: Commands added to
table.
Page 185: Commands 28 03, 28 04, and 28 05 added.
10 January 2006 Page v: Information on general precautions notation added.
Page xxiii: Information on liability and warranty added.
11 October 2006 Corrections and additions were made throughout the manual to include the following Unit:
CP-series PLCs, CJ1G-CPU@@P, X-, XA-, and Y-type CP1H CPU Units, NSJ Controllers,
and version 1 of the Serial Communications Units.
Other changes and corrections are as follows:
Pages x to xvi: Changed and expanded.
Pages xix and xx: Models and manuals added.
Page xxxiv: Added precaution on dispose of the product and batteries.
Pages 5, 149, 152, and 223: Added MEMORY CASSETTE TRANSFER command.
Page 15: Replaced most of page.
Page 19: Corrected last two rows of table.
Page 41: Changed last part of note 1.
Pages 72 and 78: Changed “PC” to “PLC” (multiple places).
Pages 84, 227, 229, and 231: Added Board column.
Page 171: Changed Comments section.
Page 191: Changed description of bits 00 and 01.
12 September 2008 Corrections and additions were made throughout the manual to include the following Unit:
CJ2H-CPU@@-EIP, and CP1L-M/L@@@@-@
Revision code Date Revised content

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron CJ - REFERENCE MANUAL 07-2009 and is the answer not in the manual?

Omron CJ - REFERENCE MANUAL 07-2009 Specifications

General IconGeneral
BrandOmron
ModelCJ - REFERENCE MANUAL 07-2009
CategoryComputer Hardware
LanguageEnglish

Related product manuals